Microplex SOLID F90 HD - _______________________________________________________________________________________________

Operation and Menu Structure 37
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
Switching the Printer OFF LINE
[SOLID F90 HD ]
ON LINE
[Menu Level 1 ]
After the printer was turned on (and as soon as the warm up phase is
finished) the printer goes into the ON LINE — Mode.
The display of the control panel shows the name of the printer.
This symbol shows the ON/OFF LINE key. If the printer is turned
OFF LINE with this key you get automatically into the first menu level.
Now this message is shown by the display of the control panel.
In the interest of simplicity, in the following chapters only the most
important display messages are shown in the Panel display column.