– 3.11 –
8) Push on the [ENTER/HOLD] key to determine
the reference length of the B direction.
9) Specify the plotting position of the adjustment
pattern.
Offset the all the line segment (AR, AL, B) inside of a sheet.
10) Push on the [ENTER/HOLD] key.
The device plots an adjustment pattern.
* If no sheet is placed on the device, or the sheet
size is too small to plot a reference length, the
device will not conduct plotting and proceed to
the correction value inputting stage.
11) Upon completion of plotting, the device will
give the current compensation value on the
LCD.
12) Measure the ON line along A- and B-axis.
Measure the line without a sheet by tilting the clamp lever
toward you.
13) Perform step1 to step11.
Since there is no sheet set, the input compensation value
screen will be displayed.
14) In case the reference value and the actual
value differ, change the correction value with
the jog keys [ ] or [ ].
15) Determine the AR direction correction value
with the [ENTER/HOLD] key or jog key [
].
16) Input the AL direction correction value as the
step14.
17) Determine the AL direction correction value
with the [ENTER/HOLD] key or jog key [
].
18) Change the B direction correction value with
the jog keys [
] or [ ].
19) Determine the B direction correction value with
the [ENTER/HOLD] key.
Return to the local mode.
AR=0.0 AL=0.0
AR=1.0 AL=0.0
AR=1.0 AL=0.0
B=0.0
B=0.5
CT1 020 050 0.30
AR=1.0 AL=1.5
DRAW SHIFT= 0mm
DRAW SHIFT=10mm
To Next Page
Loading...
Need help?
General
