Chapter 1 Before Use
1-13
1
2
2
2
2
(2) Tighten the special cap securely onto the
bottle by using the tightening jig.
(3) Turn the bottle upside down to confirm that
no ink leaks out.
4
Insert the ink bottle into the tank.
• Slide the lever on the tank all the way to the right,
and then insert the ink bottle into the tank.
5
Slide the lever on the tank from right to
left.
6
Insert an IC chip into the slot.
• Insert an IC chip into the slot, with the metal part
facing upward. Incorrectly inserting the IC chip
can lead to failure or cause the IC chip to break.
• Do not touch the metal part of the IC chip. Doing
so can cause damage to the IC chip due to static
electricity or lead to reading failure due to stains
or scratches.
• For details about how to install the ink bottles, see
P. 7- 7 「Ink bottle installation order」.
• Turn the tightening jig until the arrow mark on the
tightening jig is aligned with the arrow mark on the
special cap.
• Do not close the special cap too tightly. Doing so
can cause damage.
• Do not leave ink bottles with the special cap
attached in a place exposed to light for a pro-
longed period of time. Doing so can cause the ink
inside to harden.
Turn the tightening jig
until on the tightening
jig is aligned with the
arrow mark on the
special cap.
Tightening jig
• Never turn the ink bottle after inserting it into the
tank, Doing so can cause ink to leak out.
To Next Page
Loading...
