Chapter 4 Cutting Function
4-8
Setting of Detecting the Registration Marks
1
Press the (MENU) (>>) keys in LOCAL
2
Press to select “CUTTING”, and then press the key
3
Select “MARK DETECT”, and then press the key.
4
Press the key.
5
Press to make settings for the following items, and then press the key
Item Value Set value
DETECT AREA -
You can configure various settings for the register mark
operation.
SCAN DIR.
DEFAULT,
0 cm,
5 cm to the
machine width
Configure the detection width for the scanning direction. The
register mark is detected while scanning is performed
bidirectionally at the set detection width.
• DEFAULT: The register mark is detected at half the
media width.
• 0 cm: The register mark is detected only in
the feed (media feed) direction.
• 5 cm to the machine width: The register mark is detected with the
set width.
FEED DIR. 10 cm to 50 cm Set the detection distance in the feed (media feed) direction.
OFFSET X 0 cm to 100 cm Set the Detection start position after the ID Cut.
About [DETECT AREA].
• SCAN DIRECTION, FEED DIRECTION, OFFSET X are as following.
FEED
DIRECTION
Detection start position
SCAN DEIRECTION
OFFSET X
Scan path for Auto MARK DETECT
The ID Cut end
position for the
data
immediately
before
[Front]
[Rear]
To Next Page
Loading...
