4-9
Chapter 4 Cutting Function
4
2
2
ID Cutting
1
Set the printed media.
• Roll media: 「Setting a Roll Media」(P.2-11)
• Leaf media:「Setting Leaf Media」(P.2-15)
2
Detect the register mark
(1) Press the in LOCAL.
(2) Press [] []key to select [MARK DETECTION], and press the key.
• This switches to the mark detection mode.
(3) Press the [] [] [] [] keys to move the luminous point of the LED pointer to the center of the register
mark.
(4) Press the key.
• The register mark is detected.
• The printer is in remote mode.
3
The cut data is automatically received and cut.
• After the ID Cut, the next register mark will be automatically detected.
4
If you have multiple pieces of data, [Auto detection -> ID Cut ] is repeated until all pieces of data
are finished.
• If you print multiple register marks and perform ID Cut, set the same shape and size for all the register marks. If any of the
register marks has a different size or shape, the ID Cut is canceled.
• You can set the area for MARK DETECT in the Mark detect area settings.
Mark Shape: Type 1
Mark Shape: Type 2
Because the shape of the register mark is different,
an error occurs and the ID Cut is canceled.
Mark Shape: Type2
Cutting direction
Mark Shape: Type1
Mark Shape: Type1
To Next Page
Loading...
