A5/A3™ Operating Instructions 046-003777-00 2 - 9
Installation Install the DGSS
3. Adjust the DGSS mounting block to appropriate height, and tighten the two screws to fix
the assembly.
FIGURE 2-6 Install the DGSS
4. Connect the outlet port of the DGSS and the hospital’s waste gas disposal system with an
EVAC hose, and then use the waste gas transfer hose to connect the inlet port of the DGSS
and the waste gas scavenging connector of the anesthesia system. Lastly, install the
reservoir bag and connect the DC power supply.
FIGURE 2-7 Connect the Hoses
DC Power Supply
Waste Gas Transfer Hose
DGSS Outlet Port
Reservoir Bag
Waste Gas Scavenging Connector
DGSS Inlet Port
To Next Page
Loading...
