System Tab System Interface
3 - 38 046-003777-00 A5/A3™ Operating Instructions
Waveform Display (software bundle version 02.02.00 and
later)
To set the waveform display:
1. Select Setup softkey > Display tab.
2. Select the Waveform Display button.
3. Select the desired waveform.
4. Select the Accept button to confirm the change, or select Cancel button to discard the
change.
3.13 System Tab
The System tab is accessible only by authorized administrative service personnel with password
access. The system tab can only be accessed in Standby mode.
NOTE: The authorized administrator should change the default
password immediately after the system is installed to prevent
unauthorized access to the System tab. The password can be
maximum of 6 digits in length containing numerals 0 to 9.
FIGURE 3-44 A5/A3 Setup Menu > System Tab
Hal Scale 0-2.5 %
Enf Scale 0-2.5 %
GAS SCALE FACTORY DEFAULT SCALE
TABLE 3-9 Factory default scale
To Next Page
Loading...
