To Next Page

To Previous Page

Spirometry Tab (A5 Only) System Interface

3 - 18 046-003777-00 A5/A3™ Operating Instructions

Small Loop Window: These small graphic windows show the baseline and reference loops. The

baseline loop (only one) is always located on the left and has a white border around its graph. The

reference loops (up to four) are located to the right of the baseline loop. The reference loops are

displayed from oldest (left) to newest (right).

The baseline loop information is displayed below the small baseline loop window. The reference loop

information is displayed in cyan highlight for the reference loop that is selected.

Large Loop Window: This graphic window shows an enlarged view of the selected reference loop

overlapped with the baseline loop.

Loop Type: The Loop Type softkey is used to choose the type of loop to review. The choices are:

Pressure - Volume, Flow - Volume and Pressure - Flow. Default loop type is Pressure - Volume

loop.

Delete Loop: The Delete Loop softkey is used to delete a selected reference loop. When a reference

loop is deleted, the newer reference loops will shift to the left. The Delete Loop softkey will be

disabled (grayed out) if no reference loops have been saved. The baseline loop cannot be deleted. It

can only be replaced by another baseline loop.

FIGURE 3-22 Review Loops window

Numeric Data Area: Displays the numerical data associated with a saved Baseline loop and saved

Reference loops. The parameters listed in column form include:

Numeric Data

Area

Selected Reference

Loop (small)

Selected

Reference

Loop (large)

Non-selected

Baseline Loop

Non-selected

Reference Loop

Non-selected Reference

Loop

Mindray A5 Operating Instructions

Other manuals for Mindray A5