12-6
12.6 Understanding the NIBP Numerics
The NIBP display shows numerics only as below. Your display may be configured to look slightly different.
1. Systolic pressure
2. Diastolic pressure
3. Mean pressure obtained after the measurement and cuff pressure obtained during the measurement
If the NIBP measurement exceeds the measurement range, “---” will be displayed.
12.7 Changing NIBP Settings
By selecting the NIBP parameter window, you can enter the [NIBP Setup] menu.
12.7.1 Setting the Initial Cuff Inflation Pressure
You can set the initial cuff inflation pressure manually. In the [NIBP Setup] menu, select [Initial Pressure] and then
select the appropriate setting.
NOTE
For known hypertensive patients, you need to set initial cuff pressure to a higher value to reduce the
measurement time.
12.7.2 Setting NIBP Alarm Properties
Select [Alarm Setup >>] from the [NIBP Setup] menu. You can set the alarm properties for this parameter in the popup
menu.
12.7.3 Displaying NIBP List
Select [Main Menu]→[Screens]→[Screen Setup]. You can set [NIBP List] to be displayed at the bottom area of the
screen. Then, multiple sets of most recent NIBP measurements will be displayed. And PR displayed is derived from NIBP.
You can display NIBP list only in normal screen.
12.7.4 Setting the Pressure Unit
Select [Unit Setup >>] from the [User Maintenance] menu. In the popup menu, select [Press. Unit] and toggle
between [mmHg] and [kPa].
21
3
To Next Page
Loading...
Need help?
General
