EasyManuals Logo

Mindray BeneView T1 User Manual

Mindray BeneView T1
286 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
6-3
6.4 Setting Default Configuration
The monitor will load the pre-set default configuration in the following cases.
The patient monitor restarts after quitting over 120 seconds.
A patient is admitted.
A patient is discharged.
Patient data is cleared.
Patient category is changed.
To set default configuration:
1. Select [Select Default Config. >>] in the [Manage Configuration] menu.
2. In the [Select Default Config.] menu, select [Load the Latest Config.] or [Load Specified Config.].
When you select [Load Specified Config.], the configuration (adult, pediatric or neonate) to be restored is subject to the
patient category. This configuration can be either factory configuration or saved user configuration. Take adult as an
example, select [Default Adu Config.] and toggle between [Defaults] or user configuration(s).
NOTE
When the patient monitor starts, it shows what configuration is restored at the prompt information area for
about 10 seconds.
6.5 Saving Current Settings
Current settings can be saved as user configuration. Up to 3 user configurations can be saved.
To save current settings:
1. Select [Save Current Settings As >>] in the [Manage Configuration] menu.
2. In the popup dialog box, enter the configuration name and then select [Ok].

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mindray BeneView T1 and is the answer not in the manual?

Mindray BeneView T1 Specifications

General IconGeneral
BrandMindray
ModelBeneView T1
CategoryMedical Equipment
LanguageEnglish

Related product manuals