Mindray BeneView T1 User Manual

2-9
2.6 Installation
T1 in Use with the T1 Handle
You can install the T1 and an external parameter module, if needed, to the T1 handle as indicated below:
Firmly push T1 or the external module until you hear that the clip (refer to 2.2.4 Bottom View) engages the T1 handle.
To ensure that T1 or the external module is properly connected, try to pull T1 or the external module outward. T1 or the
external module properly engages the T1 handle if you cannot pull it out.
Caution
 To prevent T1 or the external module from falling off, after insert T1 or the external module into the T1
handle, always check that T1 or the external module properly engages the T1 handle.
 When the external module is properly installed, you should further fasten the module to the T1 handle
with the lock at the bottom of the module to ensure the engagement.
To remove the T1 or external parameter module:
1. Press and hold the latch at the bottom of the T1 or parameter module. If the external module is locked to the T1
handle, unlock it first.
2. Pull the T1 or parameter module out as indicated.
CAUTION
 To prevent T1 from falling off, do not press the release button while transferring T1 with the T1 handle.

Mindray BeneView T1 Specifications

General

Brand	Mindray
Model	BeneView T1
Category	Medical Equipment
Language	English