6-5
6.8 Transferring a Configuration
When installing several monitors with identical user configuration it is not necessary to set each unit separately. An USB
drive may be used to transfer the configuration from monitor to monitor.
To export the current monitor’s configuration:
1. Connect a USB Drive to the T1 dock station’s USB connector.
2. Select [Export Config. >>] in the [Manage Configuration] menu.
3. In the [Export Config.] menu, select the configurations and [User Maintenance Settings] to export. Then select
the [Export] button.
To import the configuration on the USB drive to the monitor:
1. Connect the USB Drive to theT1 docking station’s USB connector.
2. Select [Import Config. >>] in the [Manage Configuration] menu.
3. In the [Import Config.] menu, select the configurations and [User Maintenance Settings] to import. Then select
the [Import] button. A status message will report completion of the transfer.
6.9 Loading a Configuration
You may make changes to some settings during operation. However, these changes or the pre-selected configuration
may not be appropriate for the newly admitted patient. Therefore, the monitor allows you to load a desired
configuration so as to ensure that all the settings are appropriate for your patient.
To load a configuration,
1. Select [Load Configuration >>] from the main menu. The popup menu shows the existing configurations on the
monitor. Selecting [Config. on USB drive >>] will show the existing configurations on the USB drive.
2. Select a desired configuration.
3. Select [Load] to load this configuration.
To Next Page
Loading...
Need help?
General
