20-1
20 Other Functions
20.1 Analog Output
The monitor is configured with a multifunction connector for analog output. You can contact your service personnel for
more details.
20.2 Exporting the Log
The monitor stores system status information, including failures, abnormity, and technical alarms, into the log. You can
export the log to a USB drive.
To export the log,
1. Connect a USB drive to the monitor’s USB connector.
2. Select [Main Menu]→[Maintenance >>]→[User Maintenance >>]→enter the required password→[Others >>].
3. Select [Export Log].
20.3 Transferring Data
You can transfer the patient data saved in the monitor to a PC via a crossover network cable or SD storage card, or within
a LAN for data management, review or print.
20.3.1 Data Export System
You must install the data export system on the intended PC before performing the data transfer operation. Refer to the
document accompanying the installation CD-ROM for installation instructions.
The data transfer feature supports patient management, data review, data format conversion, print, etc. in addition to
data transfer. Refer to the help file of the system software for more details.
To Next Page
Loading...
Need help?
General
