Comments and Body Marks 9-3
h Type the alphanumeric characters through the qwerty (The default
characters are uppercase).
h To type the upper characters, press <Shift> on the control panel and the
character key at the same time.
(3) Move to a new line:
In the edit status (the characters are in green color), press <Enter> to move the
cursor to the new line, and the location of the cursor is aligned with that of the
first line.
(4) In the edit status, move the trackball or press the multifunctional knob to confirm
the character added, and the color of the character added turns yellow.
îš„ Adding a comment text
Move the cursor onto the desired comment text in the menu and press <Set> or the
multifunctional knob, and then the system adds the selected comment text on the set
location. The added comment text is in the edit status, so you can edit the comment
text added.
z Add combined comment
a) Press <Menu> or the multifunctional knob to show the menu.
b) Rotate the multifunctional knob to view the comments one by one
c) Press the knob again to add the selected item onto the image (comment
added in an editable state)
d) Rotate the multifunctional knob to search for the next part, and press the
knob again to add the second part of the combined comment.
e) Repeat procedures to add other parts of a combined comment.
f) Press <Set> to complete the comment.
îš„ Adding an arrow
You can add an arrow to a location where you want to pay attention.
(1) Press <F12> (Arrow) key, and an arrow will appear at the default position.
(2) Adjust the arrow
h Adjust the position and orientation of the arrow: roll the trackball to the
desired position and use the multifunctional knob to change the orientation
in 15° increments.
h Click the [Arrow Size] item on the soft menu to change the arrow size.
(3) Press <Set> or <Enter> to anchor the arrow position, and then the arrow turns
yellow.
(4) Repeat the above steps to add more arrows if necessary.
(5) Press <F12> (Arrow) key, <Esc> or to exit the arrow comment status.
9.1.4 Moving Comments
1. Move the cursor onto the comment that needs to be moved. Press <Set> to select it,
and a highlighted box appears around the comment.
2. Roll the trackball to move the comment to the new position.
3. Press the <Set> key to anchor the comment in the new position, and the comment-
moving operation is complete.
To Next Page
Loading...
Need help?
General
