13-30 Probes and Biopsy
îš„ Adjust angle
Move the cursor onto [Angle], press <Set> key to change the guide line angle. This is
operative when there is only one guide line displayed.
îš„ Save verified settings
After the position and angle of the guide line are adjusted, click [Save], and the
system will save the current settings of the guide line. When enter biopsy again, the
displayed Position and Angle are the verified value.
îš„ Restore the factory default settings
Click [Load Factory], and the position and angle of the guide line will be restored to
the factory default settings.
îš„ Exit the biopsy verify status
Click [Exit], and the system will exit the verification status of the guide line.
NOTE: For bi-planar probe applied biopsy, the verification is performed on the first
guide line, the other guide lines can move together with the first one in parallel.
13.2.5 Removing the Needle-guided Bracket
îš„ NGB-004
Hold the probe in the left hand, unscrew the locking nut with the right hand to open
the retaining clamp, and then raise the needle-guided bracket to separate the
locating bulge from the locating grooves.
îš„ NGB-005
Hold the probe and the needle-guided bracket; open the grip knob of the needle-
guided bracket.
îš„ NGB-006
Metal needle-guided bracket:
(1) Screw out the nut on the guiding block to loose the guiding block and the needle-
guided bracket.
(2) Take the guiding block away in the direction of the needle tail, and then separate
the needle from the transducer and the residual parts of the needle-guided
bracket.
(3) Screw out the locking nut on the needle-guided bracket to loose the bracket with
the transducer.
To Next Page
Loading...
Need help?
General
