Mindray DC-N3S

Exam Preparation 4-9
4.6 Pause & End an Exam
4.6.1 Pause Exam
 Sometimes, you have to stop an uncompleted exam due to some special reasons.
When the exam is paused, the system can begin other exams.
(1) Press <Patient> to enter Patient Info screen.
(2) Click [Pause Exam].
 If the system is powered off during scanning, the exam status turns "paused" after
the system restart.
Only one exam can be paused every time.
When an exam is paused, the system will:
(1) Save the exam-related images, reports and measurement data, modifies the
status as “Paused”.
(2) Save the exam information, including imaging mode, exam mode, image
parameters, operation mode and so on.
4.6.2 End Exam
Before examining a new patient, press <End Exam> to end the exam of the previous
patient, update the patient ID and information, to avoid mixing data of the next new
patient.
To end an exam, you can do one of the following:
z Press <End Exam> on the control panel.
z Click [New Patient] on the Patient Info screen to end the last patient exam and
clear the patient information.
z Click [New Exam] on the Patient Info screen (or iStation screen, or Review
screen) to end the last exam and clear the exam data.