13-12 Probes and Biopsy
cautions during use.Do not soak the transducer connector or the cable near it
into water or any solution.
z Soak the transducer into the disinfectant solution for the shortest time the
manufacturer recommends (for example, the shortest time recommended by the
manufacturer for soaking Cidex OPA is 12 minutes).
z Follow local regulations when selecting and using the disinfectant.
3. Rinse the transducer with plenty of sterile water (about 2 gallons) for at least 1
minute to remove all chemical residues on it.Or, follow the rinsing method
recommended by the disinfectant manufacturer to rinse the transducer.
4. Wipe off the water on the transducer with sterile cloth or gauze after rinsing it.Do not
dry the transducer by heating.
NOTE: Observe the graph here carefully to immerse the transducer. Only soak
parts of the transducer below the strain relief.
Compatible Disinfectants
Please see the diainfectant compatible chart for the proper disinfectant for the probe of
the Diagnostic Ultrasound System.
13.1.6 Storage and Transportation
When all examinations for the day have been completed, confirm that the probe is in
good condition. After disinfecting the probe, confirm that the probe is in good condition
and store it in a suitable place so that the next examination can be conducted smoothly.
1. To prevent the probe from being damaged, DO NOT store it in locations where it may
be exposed to:
z Direct sunlight or X-rays
z Sudden changes in temperature
z Dust
z Excessive vibration
z Heat generators
2. Store and transport the probe under the following ambient conditions:
z Ambient temperature: -20°C ～ 55°C
Strain relief
Probe handle
To Next Page
Loading...
Need help?
General
