Mindray uMEC12 Operator's Manual

20-4
20.4.6 Clearing Recording Tasks
In the [Record Setup] menu, select [Clear All Tasks]. All queued recording tasks are cleared
and the current recording is stopped.
20.5 Loading Paper
1. Use the latch at the upper right of the recorder door to pull the door open.
2. Insert a new roll into the compartment as shown below.
3. Close the recorder door.
4. Check if paper is loaded correctly and the paper end is feeding from the top.
CAUTION
z Use only specified thermal paper. Otherwise, it may cause damage to the
recorder’s printhead, the recorder may be unable to print, or poor print quality
may result.
z Never pull the recorder paper with force when a recording is in process.
Otherwise, it may cause damage to the recorder.
z Do not leave the recorder door open unless you reload paper or remove troubles.
Paper roll

Mindray uMEC12 Specifications

General

Type	Patient Monitor
Display	12.1-inch color TFT
ECG	3-lead
SpO2	Yes
NIBP	Yes
Respiration	Yes
Temperature	Yes
Battery	Rechargeable lithium-ion
Networking	Ethernet
Parameters	ECG, SpO2, NIBP, Respiration, Temperature
Connectivity	Ethernet
Battery Life	Up to 4 hours
Power Supply	100-240 VAC, 50/60 Hz