7-13
7.5.5 Setting Recording Length
You can change the length of the recorded waveforms. In the [Others] window of the
[Alarm Setup] menu, select [Recording Length] and toggle between [8 s], [16 s] and
[32s]:
 [8 s]: 4 seconds respectively before and after the alarm or manual event trigger
moment.
 [16 s]: 8 seconds respectively before and after the alarm or manual event trigger
moment.
 [32 s]: 16 seconds respectively before and after the alarm or manual event trigger
moment.
7.6 Pausing Alarms
If you want to temporarily prevent alarms from sounding, you can pause alarms by pressing
the
hardkey on the monitor’s front. When alarms are paused:
 No alarm lamps flash and no alarms are sounded.
 No numeric and alarm limit flash.
 No alarm messages are shown.
 The remaining pause time is displayed in the physiological alarm area.
 The
alarms paused symbol is displayed in the alarm symbol area.
The patient monitor enters into the alarm paused status as soon as it is turned on. The alarm
pause time is fixed to be 2 minutes.
When the alarm pause time expires, the alarm paused status is automatically cancelled and
the alarm tone will sound. You can also cancel the alarm paused status by pressing the
hardkey.
The alarm pause time can be set to [1 min], [2 min], [3 min], [5 min], [10 min], [15 min]
or [Permanent]. The default alarm pause time is 2 minutes.
1. Select [Main Menu]Ä—[Maintenance >>]Ä—[User Maintenance >>]Ä—enter the
required password.
2. Select [Alarm Setup >>]Ä—[Alarm Pause Time] and then select the appropriate
setting from the popup list.
To Next Page
Loading...
Need help?
General
