B-2
Guidance and Declaration - Electromagnetic Emissions
The device is intended for use in the electromagnetic environment specified below. The customer
or the user of the device should assure that it is used in such an environment.
Emission tests Compliance Electromagnetic environment - guidance
Radio frequency (RF)
emissions CISPR 11
Group 1 The device uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions CISPR 11 Class A The device is suitable for use in all
establishments other than domestic and those
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes
Harmonic emissions
IEC61000-3-2
Class A
Voltage Fluctuations/Flicker
Emissions IEC 61000-3-3
Complies
WARNING
z This device is intended for use by healthcare professionals only. This equipment/
system may cause radio interference or may disrupt the operation of nearby
equipment. It may be necessary to take mitigation measures, such as re-orienting
or relocating the [ME EQUIPMENT or ME SYSTEM] or shielding the location.
If the system is operated within the electromagnetic environment listed in Table Guidance
and Declaration —Electromagnetic Immunity, the system will remain safe and provide the
following essential performance,
Operating mode
Accuracy
Function
Accessories identification
Data stored
Alarm
Detect for connection
To Next Page
Loading...
