PRO-2000 Installation and Operation Manual
73
DISPLAY
The indicators on the display panel flash as each new event occurs and remain steady-on when acknowledged.
Resetting or clearing an event state causes the corresponding LEDs to flash then extinguish.
Alarm indicator
The Red indicator illuminates/flashes on detection of an alarm condition. Rapid flashing
indicates new alarms, slow flashing indicates cleared alarms, and steady-on to indicate
acknowledged alarms.
Alarm push button Pressing the push button displays the alarm list on the LCD.
Supervisory indicator
The Yellow indicator illuminates when a Supervisory condition has been detected.
Flashing indicates a new event, steady-on indicates an acknowledged event.
Supervisory push button Pressing the push button displays the supervisory list on the LCD.
Trouble indicator
The Yellow indicator illuminates when a Trouble condition has been detected. Flashing
indicates a new event, steady-on indicates an acknowledged event.
Trouble push button Pressing the push button displays the trouble list on the LCD.
Lamp Test push button
Tests all indicators on the panel. Press and hold to illuminate the indicators, display all the
character dots on the LCD and activate the buzzer.
Next/Previous/First/Last
push buttons
Allow scrolling through the selected event list. You can use the Next/Previous/First/Last
arrows in the Display area to move up and down the event list in the LCD one entry at a
time or to skip directory to the beginning or the end of the list.
More push button Provides additional details on the currently displayed event condition in the LCD.
Status indicator
The Yellow indicator illuminates when a Status event occurs. Flashing indicates a new
event, steady-on indicates an acknowledged event.
Status push button Pressing the push button displays the status list on the LCD.
Service indicator The Yellow indicator illuminates when a device is placed in service mode.
Service push button Pressing the push button displays the service list on the LCD.
Isolate indicator The Yellow indicator illuminates when a device is placed in isolate mode.
Isolate push button Pressing the push button displays the isolate list on the LCD.
Table 29: Indicators and Push buttons from Display Panel
To Next Page
Loading...
Need help?
General
