Mircom PRO-2000 Series User Manual

PRO-2000 Installation and Operation Manual
67
FROM LAST MODULE/DETECTOR
47KOhm EOL Resistor
CIRCUIT SUPERVISED AND POWER-LIMITED
LPY+
LPY-
LPX+
LPX-
POWER-LIMITED CIRCUITS
Note 1
Note 1
MONITOR
MODULE
M500M
NOTE 5
NOTE 4
-
+
NOTES:
1/4W, 5%
47K OHMS
1/4W, 5%
EOL RES.
TO NEXT MODULE/DETECTOR
Note 1
(Loop configuration optional)
(loop mode)
To ADI card
connections
addressable
loop
MODULE
MONITOR
M500M
M500C
CONTROL
MODULE
type PLF, PLFA,
PLFP+PLFR
Power limited circuit
Class B circuit
EOL Resistor is supplied with the Monitor Module.
Manual release switch (Mircom No. 210-13495-00)
UL listed only. (ULC Canada)
Abort switch (self restoring switch)
UL listed only. (ULC Canada)
1.
2.
3.
For NAC circuits use only UL Listed for Fire Protective
Signaling Systems (ULC Listed in Canada) regulated,
isolated 24VDC power supply (supervised and power limited).
For Releasing circuits use Special Application Mircom
APS-14127-00 Auxiliary Power Supply.
4.
Do not use looped wire on terminals 3 and 4
.
Break wire run to provide supervision of
connection.
Use UL listed (ULC Canada) NAC devices
Max.Load: 1.5A, 24VDC.
General Alarm NAC devices
Release NAC devices Max.Load: 1.5A, 24VDC.
Release Device (Valve, Solenoid)
Max.Load: 1.5A, 24VDC
Min.Load: 0.005A, 24VDC
Use UL listed (ULC Canada)
UL listed (ULC Canada) EOL relay N.O. contacts
(24VDC COIL)
Use only cables
5.
6.
7.
8.
9.
10.
11.
Note 10
Note 6,7
Note 6,8
Note 10
Note 9
Note 1
0
Note 3
Note 2
1
2
3
4
(-)
(-)
(+)
(+)
(-)
(+)
(+)
(-)
6
7
8
9
5
(-)
5
6
7
8
9
(+)
(+)
(-)
(+)
(+)
(-)
(-)
4
3
2
1
(-)
5
6
7
8
9
(+)
(+)
(-)
(+)
(+)
(-)
(-)
4
3
2
1
(-)
17
(+)
(-)
6
(+)
2
62
(-)
(+) (-)
(+)
17
47KOhm EOL Resistor
24VDC
POWER
SUPPLY
EOL RES.
1/4W, 5%
47K OHMS
Note 1
1/4W, 5%
Use UL listed (ULC Canada).
MODULE
CONTROL
M500C
M500C
CONTROL
MODULE
If multiple zones are configured in a system , each
one should have its own power supply and style 7
wiring should be used for the SLC. Isolation should be
provided between the zones as per Figure 50.
Figure 51: ADI CARD - Typical Wiring
Diagram Number 1 for Control Module In

Mircom PRO-2000 Series Specifications

General

Brand	Mircom
Model	PRO-2000 Series
Category	Control Systems
Language	English