32 TABLE OPERATION
32.2 Operations of Control Method
525
32
Operation of the complete flags
The following describes the operation timings of the complete flags. Because dwell time cannot be specified, the flags turn on
immediately after the condition is met.
*1 The flag turns on only for one scan when the drive contact of the instruction turns from OFF to ON.
*2 Only high-speed pulse input/output module is supported.
Item FX3 compatible (Effective only at TBL instruction or
DRVTBL instruction execution)
User specification (Effective only at DRVTBL instruction
or DRVMUL instruction execution)
Instruction execution
complete flag
(SM8029)
Instruction execution
abnormal end flag
(SM8329)
Instruction execution
complete flag
Instruction execution
abnormal end flag
ON
condition
Deceleration stop with the pulse
decelerate and stop command
From when the following operation
or function is completed to when the
drive contact is turned off
• The axis is already used.
*1
• Pulse output stop command
• Limit of the moving direction
• All module reset when a stop
error occurs
*2
• All outputs disabled (SM8034)
• A table that cannot be combined
is specified.
Deceleration stop by drive
contact off or pulse decelerate
and stop command
From when the following operation
or function is completed to when the
ON OFF condition is met
• The axis is already used.
• Pulse output stop command
• Limit of the moving direction
• All module reset when a stop
error occurs
*2
• All outputs disabled (SM8034)
• Online change
• A table that cannot be combined
is specified.
ON OFF
condition
When the drive contact is turned off The flag remains on until either of the following is performed.
• Turning off the flag by the user
• Restarting the table instruction
• Shift to the next table
To Next Page
Loading...
