8.13 Protective cover for oil
8.13.2 Installation procedure
8 - 51
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
PART NAME AND
SETTINGS
5
EMC AND LOW
VOLTAGE
DIRECTIVE
6
INSTALLATION
7
WIRING
8
OPTION
3 Position the POWER LED frame of the cover to the POWER LED on the GOT front face, and the
directiveof the cover is decided.
4 One corner of the cover is pulled outside, and it hangs it on the corner of the front panel of GOT.
5 The oil cover was hung and the edge of the oil cover is sequentially obtained and obtain the oil cover to
cover rubber packing parts in the back of GOT of the front panel. (It is the order of the arrow from A side
to D side.)
Protective Cover For oil
POWER LED window
POWER LED
GOT
Protective Cover For oil
The corner is hung.
GOT
Please do not pull the oil cover more than the necessity,
and do not bend it extremely.
The seat part and the rubber part in the display part
might flake off.
The corner on the left is hung and the oil cover is hung
from A side to D side on the starting point sequentially.
A
B
C
D
To Next Page
Loading...
