18 - 3
18.2 Prior Preparations for Installing BootOS and Standard Monitor OS
18.2 Prior Preparations for Installing BootOS and
Standard Monitor OS
For the installation using GOT, the memory card storing BootOS or standard monitor OS is required.
For the method of writing BootOS and standard monitor OS in the memory card, the following three methods
are available.
(1) [To Memory Card] from GT Designer3 or GT Designer2
• GT Designer3 Version1 Screen Design Manual (Fundamentals)
(7.2 Transferring Data to Memory Card)
• GT Designer2 Version
Basic Operation/Data Transfer Manual
• 8.9 Transferring Data Using a Memory Card (PC memory card GOT)
(2) Uploading from other GOT (BootOS or standard monitor OS has been installed)
13.
FILE DISPLAY AND COPY (PROGRAM/DATA CONTROL)
(3) Using CF card that stores data with OS boot drive set to A drive
• GT Designer3 Version1 Screen Design Manual (Fundamentals)
• GT Designer2 Version Basic Operation/Data Transfer Manual
Precautions on writing BootOS, standard monitor OS in memory card
When writing BootOS, standard monitor OS, etc. in the memory card, be sure to
execute by the utility of other GOT, GT Designer3 or GT Designer2.
The installation is not executed properly with the memory card to which uploaded
from the utility of GOT or copied by softwares other than GT Designer3 or GT
Designer2.
Note the available capacity of the memory card.
The available capacity of BootOS and standard monitor OS can be confirmed by [To
Memory Card] of GT Designer3 or GT Designer2.
Capacity of standard monitor OS
To Next Page
Loading...
