19.6 Backlight Replacement
19.6.2 Replacement procedure of backlight
19 - 8
17
ADDITION TIMES RESET
FOR MAINTENANCE TIME
NOTIFICATION
18
INSTALLATION OF
COREOS, BOOTOS AND
STANDARD MONITOR OS
19
MAINTENANCE AND
INSPECTION
20
TROUBLESHOOTING
APPENDICESINDEX
5 Remove the case after passing the battery holder through the mounting hole.
When removing, take care of not cutting the cable of the battery holder.
(Expanded figure of part A in )
6 Disconnect the cable connector of the upper (H01) backlight and the cable connector of the lower (H02)
backlight from the GOT side connectors.
7 Pull the upper backlight by pressing the projecting part of the rubber holder that fixes the backlight with
a minus driver to unfasten the backlight.
In the same way, pull the lower backlight by pressing the projection part of the rubber holder that fixes
the backlight with a minus driver to unfasten it.
(Expanded figure of part A in )
A jut of the rubber holder
To Next Page
Loading...
