20 - 32
20.3 ERROR MESSAGE AND SYSTEM ALARM
20.3.2 List of Error Message/System Alarm
595 Logging file error.
Logging file error.
When collecting data again, delete logging files and
management files.
596
Logging setting does not
exist or setting value
error.
The logging setting specified in the historical trend graph
setting does not exist.
Review the historical trend graph setting and specify a logging
setting that exists.
597
The specified logging ID
does not exist.
Check the logging ID in the historical trend graph setting.
1. When setting the logging, enter an existing logging ID.
2. When setting the logging ID by using a device or the
graph offset function, specify the device for the logging ID
set in the logging setting.
598
The specified logging
setting is incompatible.
1. Configure the setting so that the number of logging
devices set for the logging ID exceeds that of data lines on
the historical trend graph.
2. Configure the setting so that the data type of the logging
device set for the logging ID is the same as that of the
device specified in the historical trend graph.
600
Unsupported version of
printer unit.
The version of OS installed in the GOT is not compatible with
the printer unit.
Install the extended function OS (Printer) with the latest GT
Designer3 or GT Designer2.
601 Printer unit error.
The printer unit is installed incorrectly. The built-in flash
memory of the printer unit is broken or the guaranteed life has
been elapsed.
Check that the printer unit is installed correctly.
When the printer unit has been installed correctly, the built-in
flash memory is broken or the guaranteed life has been
elapsed. Replace the printer unit with new one.
602
Video/RGB unit not
mounted
1. Check if the video/RGB input unit is installed.
2. Check if the GOT used supports video/RGB input.
603 External I/O unit error Check if the external I/O unit is correctly installed.
604 Sound output unit error Check if the sound output unit is correctly installed.
610
Insufficient memory
capacity.
The memory capacity for the MES interface function is
insufficient.
Delete unnecessary files, and reserve memory.
611
Improper job files.
Confirm job setting.
The contents for job files are unmatched with the settings for
job files.
Check if there are mistakes in the settings on the setting
screen.
612
Cannot access Logging
Files Check the memory
card
1. Insert a memory card.
2. Turn on the memory card access switch.
3. If the memory card has unnecessary files, delete the files.
Error
code
Error message Action
Channel
No.
storage
To Next Page
Loading...
Need help?
General
