COMPONENT
SERVICE-METERS AND GAUGiS
Removal
1. Remove the cqtibination nieter. (Refer to p. 8-134.)
2. Remove the pad. (16W781)
3. Remove the meter case attaching screws.
4. Disconnect the. connectors of the meter harness located
behind the meter case.
5. Remove the inclinometer from the meter case.
Caution
To prevent internal trouble, the meter must not be dropped
or subjected to shock or must not be abruptly inclined to the
extent that the maximum indication angle is exceeded.
Installation
1. Make sure that all water bubbles in the oil case are
collected in the upper bubble collecting portion before
installation. (16W780)
2. With the vehicle in a level p&on (unladen), check to
ensure that the spherical dial. and pointer indicate a level
position.
3. If the spherical dial and pointer do not indicate that the
vehicle is level, adjust the inclinometer by insefting shims
between it tid either the combination gauge bracket or
the instrument panel. If the pointer indication is very far
from horizontal, replace the inclinometer.
OIL PRESSURE GAUGE AND UNIT
Removal
1. Remove the combination meter.
2., Remove the pad.
3. Disconnect the oil pressure gauge from thk meter wiring
harness.
4. Remove the oil pressure gauge. td meter case attaching
screws.
Inspection
OIL PRESSURE GAUGE INDICATION TEST
Disconnect the wiring connector from the oil pressure gauge
unit inside the engine compaitment.
Connect a resistance to the connector, and then confirm
the gauge indications. (16W785, 16W 597)
-
Indication point Resistance valuk
16W76
Bubble coilming portion
16W761
i (1) 588 kPa(85 psi) 12Oa ;
8-140
To Next Page
Loading...
