COMPONENT SERVICE-WINDSHIELD WIPERS AND WASHER
COMPONENTS
1. Wipers and washer switch assembly
2. Wiper blade
3. Wiper arm .
4. Wiper linkage
5. Wiper motor
6. Washer nozzle
7. Washer motor
8. Washer tank
9. Intermittent wiper relay
Nm ft.lbs.
A lo-16 7-12
B 7 5
C 3 2
1
16W712
i
3
16W570
WIPER MOTOR AND LINKAGE
Removal
1. Remove the wiper arms and the pivot shaft mounting
nuts, then push the pivot shafts toward the inside.
2. Loosen the wiper motor mounting bolts, and then-with
the motor pulled out slightly, disconnect the linkage and
the motor. (C16555)
3. Remove both the motor and the linkage.
Caution
Because the installation angle of the crank arm and the motor
has been set, do not separate them unless it is necessary to do
so. If they must be separated, do so only after marking the
mounting positions.
Installation
Install the wiper arms on the pivot shafts so that the stopping
position of the wiper blades is at the specified point.
(16Y1568)
Wiper blade stopping position (distance between
blade tip and front deck garnish) . . . . . . . . . . . . .
37-47 mm (1.5-1.9 in.)
16Y1561
To Next Page
Loading...
