cl
-+
COMPONENT SERVICE-REAR
WINDOW DEFOGGER
2. Shake the electroconductive paint container well, and
remove the amount of paint needed. Dilute it with a
small quantity of paint thinner, and apply three coats
with the brush at intervals of about 15 minutes.
3. Remove the tape or decal and leave the repaired defogger
unused for a while before supplying power.
4. For a better finish, scrape away excess deposits with a
knife after drying is complete (one day later).
Caution
After repair, clean the glass with a soft dry shop towel or
wipe along the printed heater line with a slightly moistened
shop towel.
REAR’ WINDOW DEFOGGER SWITCH
Removal
Remove the switch from the instrument cluster and push the
connector bar to detach the switch.
Inspection
.Operate the switch and check continuity between the termi-
nals.
OFF o--@--o
ON
NOTE
* Denotes indicator light.
, .
6
5
I
16W696
8-160
To Next Page
Loading...
