TROUBLESHOOTING
Fasten Seat Belt Warning Light and Buzzer ;
Fasten seat belt warning light
does not illuminate when
ignition key is turned to “ON”
with driver’s seat belt not
buckled.
Check with ignition key in
“OFF” position
1
t
Is fuse No. 7 good?
No
.Repair harness and replace fuse
*
Yes
Is there continuity between CR No Open circuit in harness between
wire of key-reminder switch
Repair the harness
* fuse block and key-reminder
*
connector and ground?
switch
Yes
Is there continuity between-G
Key-reminder switch defective
wire of key-reminder switch
No
Replace the key-reminder switch
w *
connector and ground?
IYes
-7
Is there 12 V between G wire
at back of connector of corn-’
No
Open circuit in harness between Repair the harness
w key-reminder switch and combina-
c
bination meter and ground?
tion meter
IYes
When 0.3-YB wire at back of
No
Open circuit in light bulb
connector of combination
Repair the light bulb
meter is grounded, does the
e *
warning light illuminate?
4.
Yes
Is there 12 V between 0.3-YB
Repair the harness
wire at back of connector of
No combinatifon meter and seat belt
seat belt warning timer and
.
ground
t
I Yes
NOTE
Set ignition key to “ON”
If the malfunction is in the following circuits, in addition to the warning light
1
not illuminating, the buzzer will not sound.
Is fuse No. 3 good?
?&No -jmFI -71
Yes
. * .
Is there 12 V between 0.3-RL
No
Open circuit in harness between
Repair the harness
wire at back of connector of fuse block. and seat belt warning
seat belt warning timer and
* timer
t
ground?
,
Yes
Replace the belt warning timer
8-40