M Series AC Servo
User Manual
143
Rev. 1.0
7/31/2019
400-820-9661
In homing mode, after end of travel is reached, this sets the velocity rate for seeking the homing switch.
Please refer to parameter P-91 (HA)
P-99 (HV)
Velocity of feeding to homing
switch during homing
Data Range Default Unit Data type
0.167~5000 10 rps/s DEC
In homing mode, after the homing switch is reached it sets the velocity rate for feed back to the homing
switch.
Please refer to parameter P-91 (HA)
P-100 (KL) Follow factor
Data Range Default Unit Data type
-32000~+32000 0 DEC
Servo follow factor: Higher value will reduce system noise, eliminate the overshoot, but it will reduce the
system dynamic following performance. Lower value will raise system stiffness, but will cause system
noise probably.
To Next Page
Loading...
