Motala MC2000 - Page 20

MC2000 – Assembly Instruction Manual
18
8. Measure and cut the lift well module with a
jigg saw if necessary. The module should
end a few millimetres below the upper ends
of the corner profiles.
9. Assemble the module/modules.
10. Use a short dimension stick and fasten the
modul
e with two screws in the upper edges
of the corner profiles.
11. Use a spirit-level and fasten the remaining
s
crews in lift well wall A.
12. Erect the modules on sides B and D. Use a
l
ong dimension stick and fasten the mod-
ules with two screws in the upper edges of
t
he corner profiles. Use a spirit-level and
fasten the remaining screws in lift well walls
B and D.
A
B
C
D
A
B
D
C