Device Configuration 5 - 333
19. Define or override the following MINT Link Settings:
20. Select the Tunnel Controller Load Balancing (Level1) option to enable load balancing on the tunnel controller.
21. Define the group name of clustered tunnel controllers in the Preferred Tunnel Controller Name field.
22. Select OK to save the changes and overrides made to the Settings tab. Select Reset to revert to the last saved
configuration.
23. Select the IP tab to display the link IP network address information shared by the devices managed by the MINT
configuration.
Figure 5-214 Device Overrides - Advanced Profile MINT screen - IP tab
The IP tab displays the IP address, Routing Level, Listening Link, Port, Forced Link, Link Cost, Hello Packet Interval and
Adjacency Hold Time managed devices use to securely communicate amongst one another.
24. Select Add to create a new Link IP configuration or Edit to override an existing MINT configuration.
MLCP IP Select this option to enable MINT Link Creation Protocol (MLCP) by IP Address. MINT
Link Creation Protocol is used to create one UDP/IP link from the device to a neighbor.
That neighboring device can be another AP.
MLCP VLAN Select this option to enable MLCP by VLAN. MLCP is used to create one VLAN link
from the device to a neighbor. That neighboring device can be another AP.
Tunnel MiNT across
extended VLAN
Select this option to enable tunneling MiNT protocol packets across extended VLANs.
To Next Page
Loading...
