Muratec F-315 Field Engineering Manual

3-4
Machine Parameter 000 ∼ 006 ––– Factory use only
Machine Parameter 007
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0
3 0
2 0
1 0
DRAM capacity indication on
the Expansion Memory
0 0 DRAM capacity indication on
the Main PCB
This switch indicates the DRAM capacity.
(This switch is read only, do not set any character)
You can see the memory capacity by how many “1”
is indicated on the LCD. One “1” means 8MB.
For example, if three “1” are indicated,
i.e. “00000111”, the DRAM capacity is
8MB x 3 = 24MB.
Machine Parameter 008 ––– Factory use only
Machine Parameter 009
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
3 0 Factory use only
2 0 Factory use only
1 1
0 0
Eco mode Switch 1 0
0 0 OFF
0 1 ON
1 0 Factory default (ON)
Machine Parameter 010
Switch
Initial
Setting
Adjust Usage/Comments
7 0
6 0
5 0
4 0
3 0
2 0
1 0
0 0
ADF scanner registration
adjustment (Horizontal)
Adjusts the start point to scan
the document.
The plus setting increases
the left margin and the minus
setting decreases it.
1 step = 2 / 600 dpi
(0.0847 mm)
Note: These values are
factory set and should not be
adjusted unless instructed by
a Muratec technical
representative.
Switch 76543210 Settings
127 steps 01111111 +10.76 mm
:
00100000 +2.71 mm
:
00010000 +1.36 mm
:
00001000 +0.68mm
:
00000000 0 mm Å Initial setting
:
10001000 –0.68 mm
:
10010000 –1.36 mm
:
10100000 –2.71 mm
:
–127steps 11111111 –10.76 mm

Muratec F-315 Specifications

General

Brand	Muratec
Model	F-315
Category	All in One Printer
Language	English