EFA-200/-300 11 Remote control
11-13
Only for Spectrum FFT, Harmonic Analysis modes
Continuous transmission of measured values
Select / read measured value rate
C180 <p> C181 1 to 240 Time interval =
p * 250 ms,
default = 1 s
Select transmission of header / label
C184 – – Settings and
label for
measured value
Start transmission of measured values
C186 – – End of line:
<CR><LF>
Cancel transmission of measured values
C188 – – –
Write/action
commands
Read commands Range of p Meaning or
Unit of p
Read unit of measured values
– C177 0 = T
1 = G
2 = V/m
Query validity of measured values
– C179 0 = valid
1 = in processing
2 = overdriven
Table 11-7 Remote control commands, reading out current measured values,
only for Spectrum FFT, Harmonic Analysis modes
Write / action
commands
Read commands Range of values of p Meaning or units
of p
Table 11-6 Remote control commands, read current measured values
To Next Page
Loading...
