NARDA EFA-200 - Page 149

EFA-200/-300 11 Remote control
11-15
Only for Harmonic Analysis mode
✓ The “Stop” state should be activated.
Write/action
commands
Read commands Range of p Meaning or
Unit of p
List tool
C216 <p> C217 0 = Deactivated
1 = Activated
NEXT or ESC
Read frequency of fundamental
– C219 0 – Unit: Hz
Format: <FP4D>
Read measured value of fundamental
– C219 1 – Unit:
like selection
Format:
<SCI4D>
Read harmonic factors
– C219 <p> 2...9 Unit: %
Format: <FP4D>
Read total of harmonic factors
– C219 10 – Unit: %
Format: <FP4D>
not with
detection mode
VECT PEAK
Read total noise/harmonic factor
– C219 11 – Unit: %
Format: <FP4D>
not with
detection mode
VECT PEAK
Table 11-9 Remote control commands, reading out current measured values,
only for Harmonic Analysis mode