EFA-200/-300 11 Remote control
11-29
Read firmware version
– C103 1 <version><ws>
<yy-mm-dd><ws>
<hh:mm:ss>
Version = X.XX
Read error messages after self test
– C103 2 $<error> 4 characters,
hexadecimal
Read battery charge state
– C103 3 0 = OK
1 = LOW
The remaining
operating time is
about 15 minutes
when the “LOW”
charge state
warning is output.
Read Basic Unit instrument designation
– C103 4 <device type> Max 8 characters
Read Basic Unit hardware version
– C103 5 <version>
Read Basic Unit calibration data
– C103 6 <yyyy>-<mm>-<dd>
Read Basic Unit serial no.
– C103 7 <serial number> Max 7 characters
Read active probe
– C103 8 0 = B-Field Probe /
90.10 (100
cm
2
)
1= B-Field Probe /
90.20 (3
cm)
8 = E-Field Unit
9 = B-Field Probe
(built in)
Read battery voltage
– C103 10 0.1 to 9.9 Units: V
Table 11-24 Remote control commands, test / service
To Next Page
