Note that parameters of Native Instruments and External Plug-ins are systematically as-
signed to knobs (not to switches nor selectors) in MASCHINE — this is also true in the
MASCHINE software.
A parameter of a Native Instruments or External Plug-in can be assigned to one knob
only!
To begin assigning parameters, do the following:
1. Select the Plug-in for which you want to customize parameter assignments.
2. Click the down-pointing arrow in the bottom left corner of the Control area to reveal the
Assignment area underneath:
3. Click the Pages tab in the left part of the Assignment area:
→
The Pages tab lights up and the Pages pane appears on its right. You are now ready to
assign parameters to the Parameter pages.
Working with Plug-ins
Using Native Instruments and External Plug-ins
MASCHINE - Manual - 293
To Next Page
Loading...
