â–ª Plug-ins:
â—¦ Saturator: in Tube mode, the Bass Overload button (MAIN section) and Bypass button
(EQ section).
â—¦ Percussion (Drumsynth): in Fractal mode, the Tune Hold button in the Main page.
â–ª Channel properties:
◦ Sound’s and Group’s Output properties: the Cue button in the Audio page.
◦ Group’s Input properties: the Root Note knob in the MIDI page.
◦ Master’s Groove properties: the Amount knob and Invert toggle in the Swing page.
You will notice that the rules for automatable parameters are the same as for modulata-
ble parameters except that modulatable parameters can only be found in Sounds and
Groups (not in the Master). In other words, at the Sound and Group level the same pa-
rameters are both automatable and modulatable. For more information on modulation
please refer to section ↑7.5, Recording and Editing Modulation.
Also note that your Macro Controls will be automatable if, and only if, the parameters they are
controlling are themselves automatable. For more information on Macro Controls please refer to
section ↑8.3, Creating Custom Sets of Parameters with the Macro Controls.
Assigning Host Automation IDs to Parameters (MASCHINE as Plug-in)
1. Click the down-pointing arrow in the bottom left corner of the Control area to open the
Assignment area underneath.
Audio Routing, Remote Control, and Macro Controls
Using MIDI Control and Host Automation
MASCHINE - Manual - 439
To Next Page
Loading...
Need help?
General
