6. Use Knobs 1–8 under the displays to adjust the value of the parameters available on the
selected page. For continuous parameters, hold SHIFT while turning the Knobs to adjust
the values in finer increments.
The displays showing the AUDIO page from the Group’s Output properties (OUT tab).
Using the Navigate Mode
Alternatively, you can also navigate Channel properties and Plug-ins along with their Parameter
pages via the Navigate mode of your controller:
1. Hold NAVIGATE to enter Navigate mode (or pin it by pressing NAVIGATE + Button 1).
2. Press Button 5 (CHANNEL) to display the Channel properties or Button 6 (PLUG-IN) to
display the Plug-in slots of the selected Sound, Group or the Master.
3. Press Button 3/4 to navigate the Channel properties or Plug-ins (the name of the selected
Channel properties or Plug-in appears between the left and right arrows under Button 3
and 4).
4. Press the dimmed pads to select the desired Parameter pages. The abbreviated names of
the available Parameter pages are shown on the right display along with the corresponding
pads:
Basic Concepts
Common Operations
MASCHINE - Manual - 45
To Next Page
Loading...
