9. Turn Knob 5 to browse the available Plug-ins.
10. When you have found the effect you want to use (e.g., the MASCHINE Compressor), press
Button 8 (LOAD) to load it. You can also use Button 5/6 to step through the list and load
each effect directly.
11. Switch back to Control mode by pressing CONTROL (or by pressing SHIFT + BROWSE
again).
→
Now you can edit the effect parameters using Knobs 1–8 and the Page buttons as usual
(see ↑2.3.3, Navigating Channel Properties, Plug-ins, and Parameter Pages in the Control
Area). When you load an effect into the first Plug-in slot of a Sound, MASCHINE auto-
matically configures the Sound’s input to receive any signal(s) coming from other Sounds
and Groups in your Project and sends them through its own Plug-in slots — in other
terms, you now have a send effect.
You could also load an effect preset from the Browser instead of using the Plug-in
menu. For more information on how to load effect presets, see ↑3.2, Searching and
Loading Files from the Library.
Now that the effect is loaded, we suggest that you rename the Sound slot to the Plug-in name:
this will be of great help when routing other signals to that send effect (see section below). You
can rename the Sound slot in the software as follows:
1. Double-click the name of the Sound slot in the Sound List.
The name gets highlighted, ready to be edited.
2. Type the name of the Plug-in, and press [Enter] on your computer keyboard to confirm.
→
The Sound slot now mirrors the Plug-in name.
For more information on renaming Sound slots, see section ↑4.2.3, Renaming Sound
Slots.
Using Effects
Creating a Send Effect
MASCHINE - Manual - 599
To Next Page
Loading...
Need help?
General
