Adjusting the source and mode of the recording in the software.
Selecting the Source to Record
►
Click the SOURCE selector on the left to select the type of source you want to record:
▪ To record external audio signals connected to your audio interface, select Ext. Ster. (for
stereo signals) or Ext. Mono (for mono signals).
▪ To record audio signals coming from MASCHINE itself, select Internal.
►
Click the INPUT selector to choose between the available inputs:
▪
If SOURCE is set to Ext. Ster., you can select either of MASCHINE’s four external stereo
inputs In 1–4.
▪ If SOURCE is set to Ext. Mono, you can select either of MASCHINE’s eight external mono
inputs: the left (“L”) or right (“R”) channel of each input pair In 1–4.
▪ If SOURCE is set to Internal, you can select the output of any available Group or the Mas-
ter.
You can easily record the output of a particular Sound by setting SOURCE to Internal,
soloing this Sound and selecting its parent Group in the INPUT selector!
You can also set SOURCE to Internal, choose as INPUT a Group with a drum kit loaded,
and record your live improvisations on the pads while playing this drum kit! You will
then have your own improvisations recorded as Samples, ready to be used, edited,
sliced, etc., as any other Samples in MASCHINE!
Choosing a Recording Mode
►
Click the MODE selector to select from the two available recording modes:
▪ Sync: If Sync is selected, you can synchronize the recording function to the sequencer, so
that the recording starts in sync with the sequencer after you clicked Start. The recording
will start at the top of the next bar. The LENGTH control on the right allows you to choose
Sampling and Sample Mapping
Recording a Sample
MASCHINE - Manual - 754
To Next Page
Loading...
Need help?
General
