Furthermore, If you have selected an external signal (Ext. Ster. or Ext. Mono selected in
SOURCE), an additional MONITOR section appears on the right. In this section, activate the
MONITOR button to send the input signal to the Cue bus of MASCHINE, allowing you to hear
on a separate channel (e.g., your headphones) the audio source that is about to be recorded.
For more information on how to use the Cue bus, please refer to section ↑9.2.6, Using
the Cue Bus.
Selecting the Source and the Recording Mode on Your Controller
At the bottom of the left display, the parameters in the RECORDING section allow you to ad-
just which source should be recorded and how the recording should start and stop.
Adjusting the source and mode of the recording on your controller.
Selecting the Source to Record
First choose which source you want to record using the SOURCE and INPUT parameters:
Sampling and Sample Mapping
Recording a Sample
MASCHINE - Manual - 756
To Next Page
Loading...
