Page 2 – LOOP Parameters
The parameters in the LOOP page allow you to define and adjust a portion that will play in loop
while the note is held.
The ZONE page on the controller, page 2 of 5: LOOP parameters.
Parameter Description
ACTIVE (Knob 1) Enable this to define a loop in the Sample of the focused Zone.
When the play position reaches the loop, the playback is looped as
long as the note is held. This can be useful to loop either a whole
Sample or part of it, e.g., to simulate a longer tone. Note: this
technique requires that you set the Sampler’s TYPE selector to AHD
or ADSR in the PITCH / GATE section (Parameter page 2, see
↑6.2.2, Page 2: Pitch / Envelope).
START (Knob 2) Adjusts the start point of the loop.
END (Knob 3) Adjusts the end point of the loop.
XFADE (Knob 4) Allows you to blend a little of the material near the loop start and
end points in order to get a smoother, less abrupt loop. This is
particularly helpful if the loop is inducing any clicks.
Hold SHIFT when turning the Knobs to adjust the parameters in finer increments.
By moving the loop’s start and end points closer to each other you can shrink the loop to
very small values on-the-fly, thereby creating very interesting glitch effects in a live sit-
uation.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE - Manual - 819
To Next Page
Loading...
Need help?
General
