NEC Electra Elite IPK II System - Page 1001

Electra Elite IPK II Document Revision 4C
Traffic Reports 2 - 977
Related Features
Station Message Detail Recording
Programming
 90-20-01 Traffic Report Data Setup – Call Traffic Output
Determine whether or not the Call Traffic Output should be measured.
0 = No
1 = Yes
(default: 0)
90-20-03 Traffic Report Data Setup – All Line Busy Output
90-20-04 Traffic Report Data Setup – DTMF Receiver Busy Output
90-20-05 Traffic Report Data Setup – Dial Tone Detector Busy Output
90-20-06 Traffic Report Data Setup – Caller ID Receiver Busy Output
90-20-07 Traffic Report Data Setup – Voice Mail Channel All Busy Output
90-20-08 Traffic Report Data Setup – ACD Operator All Busy Output
90-20-09 Traffic Report Data Setup – Attendant Channel All Busy Output
90-20-10 Traffic Report Data Setup – Base Station All Busy Output
 90-21-01 Traffic Report Output – Output Port Type
Define the output port to be used for the traffic reports. The reports print hourly when connected
to the output device.
0 = No Setting
1 = CPUII COM Port
2 = CPUII USB Port
3 = CPUII LAN Port
(default: 0)