Electra Elite IPK II Document Revision 4C
Multiline Conference Bridge 2 - 715
Multiline Conference Bridge
Description
Multiline Conference Bridge allows any intercom or outside caller to call the CNF(8)-U( ) ETU to place a
multiparty conference call. Each CNF(8)-U( ) ETU supports one 8-party conference or two 4-party
conferences regulated by a switch setting. Two CNF(8)-U( ) ETUs may be installed. DSP-based
amplification provides a higher quality conference call.
Conditions
The CNF(8)-U( ) ETU can be used with any version of software on the Electra Elite IPK II
system.
When CNF is set for two, four-party conferences, ports 1~4 can be set to the same Master
Hunt Group, and ports 5~8 can be set to a different Master Hunt Group using Program
11-07-01 (Department Group Pilot Numbers) and Program 16-02-01 (Department Group
Assignment for Extensions). This allows two different Pilot Numbers for each conference.
- OR -
If only one Pilot number is needed, put all eight ports in one hunt group using Program
16-02-01 (Department Group Assignment for Extensions). When the password is entered,
the conference selected is the conference you enter.
The supervisor must perform the Setting Procedures before the Conference Bridge can be
used.
Up to 16 Voice Mail ports are available. The CNF(8)-U( ) ETU reduces this number by
eight.
Each CNF(8)-U( ) ETU reduces the number of stations by eight.
Default Setting
None
System Availability
Terminals
All Multiline Terminals
To Next Page
Loading...
Need help?
General
