NEC Electra Elite IPK II System User Manual

Electra Elite IPK II Document Revision 4C
Resident System Program 2 - 839
Resident System Program
Description
When power is supplied to the system, the hardware configuration is scanned and Resident System
Program default values are assigned including terminal types (e.g. PGD(2)-U10 ADP, DSS Console).
This enables immediate operation, even before the system is programmed to accommodate the
individual site requirements.
Conditions
 Default assignments for Multiline Terminals are: LK 01~LK 08 corresponds to
CO 01~CO 08.
 DSS Console to Extension assignments for Attendant Add-On Consoles are not assigned.
 Default Attendant Add-On Console key assignments are:
DSS Keys = 001~060
Stations = 101~160
 First Initialization of the system returns all programming values to default. Without a
PC-ATA Compact Flash Card installed, press and hold the SW1 (Load Switch) and toggle
the Reset (SW2) switch. Continue to hold the SW1 switch for approximately 5~10 seconds
before releasing. The system boots loading Resident System Programming.
Default Setting
None
System Availability
Terminals
Not Applicable
Required Component(s)
None

NEC Electra Elite IPK II System Specifications

General

Brand	NEC
Model	Electra Elite IPK II System
Category	Telephone System
Language	English