EasyManua.ls Logo

NEC Electra Elite IPK II System - Distinctive Ringing, Tones and Flash Patterns

NEC Electra Elite IPK II System
1190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Electra Elite IPK II Document Revision 4C
Distinctive Ringing, Tones and Flash Patterns 2 - 369
Distinctive Ringing, Tones and Flash Patterns
Description
Distinctive Ringing, Tones and Flash Patterns provide extension users with audible and visual call status
signals. This lets users tell the types of calls by listening to the ringing/tones and watching the keys. It
also helps users monitor the progress of their calls. In addition, Distinctive Ringing lets multiline terminal
users customize their Intercom and trunk call ringing. This is helpful for users that work together closely.
For example, if several co-workers set their multiline terminals to ring at different pitches, each
co-worker can always tell which call is for them. You can also customize the tones the system uses for
splash tone, confirmation tone, trunk ring tone, Intercom ring tone and Alarm ring tone. Refer to the chart
below and the Electra Elite IPK II Programming Manual for more details
.
Conditions
Single line telephone users cannot listen to or hear the pitch of their telephone incoming
ring.
Enhancements
Version 1600 or higher:
When a Ring Group call rings a station, a BLF indication for this station shows idle or busy based on a
new Class of Service option (PRG 20-13-49). Prior to this release, the BLF indication would show busy.
Allows the flash rate and color of the Message Waiting LED to be configured for the following conditions:
Message Waiting Lamp Cycle for Calling Extension (PRG 15-02-35)
Message Waiting Lamp Cycle for Called Extension (PRG 15-02-36)
Voice Mail Message Wait Lamp Color (PRG 15-02-37)
Voice Mail Message Wait Lamp Cycle (PRG 15-02-38)
This provides more distinction between incoming calls, Message Waiting (Set/Received) and a VM
Message Waiting indication.
Table 2-18 Distinctive Ringing: Tones and Flash Patterns
Program Description
80-01-01~04 Service Tone Setup Set the frequency of the system splash tone. This is the tone the
system uses, for example, to alert the user of an incoming
voice-announced Intercom call.
30-05-02~21 DSS Console Lamp Table Set the DSS and Hotline key flash rates for busy, idle, DND, ACD
Agent status, and hotel options.

Table of Contents

Related product manuals