Electra Elite IPK II Document Revision 4C
Automatic Release 2 - 81
Automatic Release
Description
Automatic Release drops the line circuit when an outside party abandons the call. For this feature to
work with Loop Start Trunks, the CO/PBX providing the outside line must provide a timed disconnect
signal. Automatic Release is normally provided on Ground Start, DID, ISDN, and Tie Line trunks.
Conditions
Automatic Release on ISDN trunks is provided by the protocol.
When an outside line is accessed using a dedicated line key, the LED associated with the
line key goes off when Automatic Release occurs.
This feature functions while a call is in progress, on hold, or in a conference.
This feature applies to all ICM type calls in progress, holding or parked.
When Automatic Release occurs and the telephone is in handsfree mode, Speaker
automatically turns off. If using the handset, the station is set to idle when the handset
goes on-hook.
Default Settings
None
System Availability
Terminals
Not applicable
Required Component(s)
None
To Next Page
Loading...
